Wooden Pumpkins





wood pumpkin final

Wooden Pumpkins 

These wooden pumpkins are a cute way to dress up your home for fall at a fairly low cost. I am going to give measurements for these but feel free to make them whatever size you’d like! This is a perfect craft to use up those old scraps of wood laying around in the garage!

Materials List:

  • 1x6x6 Board
  • 1 shim ( for the stem)
  • chop saw ( If you do not have one of these your local home improvement stores may cut the wood for you)
  • Sander & Sandpaper
  • Spray paint ( Orange, green, & black)
  • stain – Here’s what I like to use:

  • Old rags
  • gloves
  • Small nails
  • 2 2-inch screws
  • 1 3-inch screw
  • Hammer
  • Raffia ( You can find this at the Dollar Tree!)

Step 1:  Cut the boards and Shim to the sizes below

Tall pumpkin –  17 inches

short pumpkin – 11 3/4 inches

Base – 8 inches

stems – 2 1/4 inch

 

You can use my measurements or you can just use your own.

wood pumpkin 1

Step 2: Paint the boards the following colors & allow to dry:

Stems- Green

Pumpkins – Orange

Base – Black

wood pumpkin 2http://burlapkitchen.com/2018/09/04/cement-candy-corn-yard-ornaments/

Step 3: Sand all the pieces of painted wood. I like to sand the corners extra good so it looks rustic once stained.

wood pumpkin 3http://burlapkitchen.com/2018/09/04/cement-candy-corn-yard-ornaments/

 

Step 4: Apply the stain. I like to use 2 rags, one for applying the stain, and one to wipe it off. Make sure to wear gloves while doing this or your hands will be stained for a good week or so. Allow stain to dry.

wood pumpkin 4

Step 5: Using a drill put 2 screws in the back of the larger pumpkin to hold the pumpkins together. When doing this I like to put one screw in and even things up before adding the second screw.

wood pumpkin 5http://burlapkitchen.com/2018/09/04/cement-candy-corn-yard-ornaments/

Step 6: Predrill and use a larger screw to attach the base.

Here’s an easy way to do this: When attaching the base, I like to push my screw into the wood to mark where I need to predrill. I then take my drill and predrill through the base. Next, with the drill bit through the base, I attach it to the bottom of the pumpkin and continue pre-drilling. This helps to keep things lined up nice.

Step 7: Nail on stems & raffia bow. I like to pre-drill so the shim doesn’t split.

wood pumpkin 7http://burlapkitchen.com/2018/09/04/cement-candy-corn-yard-ornaments/




Speak Your Mind

*

Captcha * Time limit is exhausted. Please reload the CAPTCHA.

%d bloggers like this: