Candy Corn Magnets

CC FINAL

What you need:

  • cupcake papers ( 1 cupcake paper makes 1 candy corn magnet)
  • Button magnets (found in the craft department at Walmart)
  • 3 paint brushes (one for each color of paint)
  • Orange, Yellow, & White paint ( I used the acrylic, plaid brand, paint at Walmart. It’s about $1 a bottle)
  • Glitter ( I used white)
  • Glue ( I used a hot glue gun because it dries fast, but school glue would work fine, too)

How to make them:

1.) First you need to fold your cupcake papers in half, then in half again, then again. With each fold place a small dab of glue to keep them from opening. Like this:

Step 1 cc -Final

2.) Paint your papers to look like a candy corn.

Step 2 CC

3.) Apply glitter while paint is still wet.

Step 3 CC

 

4.)  Let candy corns dry, then glue the magnet to the back. They make different kinds of magnets, I like the button ones because they seem to be much stronger than the others.

Step 4 CC

DIY Comic strip pencil cans

comic final

A few days ago my son and I made this cute comic strip pencil can. It was super easy and super fun to make! Not to mention I now have a cute can to store all his pencils in. Check out how easy they were to make by following the 7 steps below:
What you will need:

1- empty and clean pringle can

mod podge

foam brush

your favorite comic strips from the local paper ( about 15-20 strips)

The How to:

1.) First cut your Pringle can to the size you want it to be. I put a few pencils in the can before I cut, just to give me an idea of where to cut.

comic 1

2.) Place the Pringle can on top of one of the comic strips and trace the bottom of it. Cut the circle out.

comic 4

3.) Now here is where I went wrong. I am going to tell you how I should have done this. So… when I did this, I mod podge the entire inside of the Pringle can. After that, I placed the comic circle that was cut onto the bottom of the inside of the can. This was a sticky mess! What I should have done was ONLY mod podged the bottom of the Pringle can, then place the circular comic strip in.

(see what I did? LOL )

comic 5

4.) After you get the circle piece in, then paint the rest of the inside of the can with the mod podge, including the top of the circular piece you just put in.

comic 6

5.) Take your strips and stick them vertically or horizontally ( however they fit and however you want them to go) to the inside of the can. Paint over top of the comic strips with Mod podge.

comic 7

* You will want to fold the strips over the can to the other side that has been painted with mod podge ( read next step)

comic 8

6.) Paint the outside of the can and place the comic strips on the same way you did the inside of the can. Paint over top of the comic strips when finished.

comic 9

7.) Let dry for a few hours or overnight.

comic 10

Are they cute or what? These would be so cute sitting on a desk or shelf in a kids play or learning room. Load them up with some pens and pencils and they would make a cute and inexpensive gift for a teacher. Not to mention it will give them a good laugh throughout the day 😉

%d bloggers like this: